Isoflex IFV75-20S Engine Mount for Fiat-Iveco, Caterpillar, Cummins & Other Marine Engines

Isoflex self-aligning adjusters increase the mount's stud strength up to 3x by providing a compression fit. Adjusters allow up to 4 degrees of bracket-to-bearer misalignment to reduce point loading.

• Stud size 3/4" (M20)
• 5" mounting center (127mm)
• Minimum free height 3.15" (80mm)
• Replaces factory mounts for Fiat-Iveco, Caterpillar, Cummins, Detroit, AGCO SISU
• Provides at least 85% vibration isolation at worst case engine idle (4cyl and above) = less equipment fatigue, maintenance and associated noise
• Encapsulated core allows for fine tuning of inverted stiffness
• Resilient element co-polymer resists fuel, oils, water and hydraulic fluids
• Hold-down bolt slots can be rotated to any direction for easier installation
• Fail safe

Replaces Isoflex M75-20S mount.

Supported Engine Models

AGCO SISU: 44CTIM, 49CTIM, 66CTIM

Caterpillar: 3054-T, 3054B-NA, 3056-NA, 3056-TA, 3114-T, 3114-TA, 3116, 3126-TA, 3126B-TA

Cummins: 370B, 6B5.9M(120B), 6BT5.9M(220B), 6BTA5.9M, 6BTA5.9M1(270B), 6BTA5.9M2(330B), QSB5.9

Detroit: 6V53 TI, 8-2T

Fiat-Iveco: 8061 SM20, 8061 SRM25, 8061 SRM33, 8361 M16, CURSOR 8, N60 370 (N60 ENT M37), N60 400 (N60 ENT M40), N60 480 (N60 ENT M40), N67 150 (N67 MNA M15), N67 220 (N67 MNS M22), N67 280 (N67 MNT M28), N67 450 (N67 ENT M45), N67 560 (N67 ENT M56), NEF 6

Download IFV75-20S Data Sheet

Download Data Sheet